Burnt-out lamp, don’t waste your money: the electrician’s technique to fix it in 1 minute

It can happen several times that a light bulb burns out. This is a very common problem, but you don’t need to worry because there is a way to fix it. No need to call an electrician, you can have it fixed in less than 60 seconds. You save money and time: let’s find out more.

If you have a burnt-out light bulb at home, don’t think about throwing it away or replacing it, because you can fix it in just a few steps. In one minute you will have solved the problem with this method, unbelievable to believe, but it’s true. Stop throwing money away because you can fix it with little money. This technique is used by electricians and is really very simple: let’s find out how to do it.

Burnt out bulb: that’s why it happens!
The light bulb can burn out for various reasons. For example, if the voltage of the mains supply in the house is too high. Avoid switching the light bulb on and off too often during the day, as this can lead to an electric shock.

This happens even if a connection is not properly hooked into the socket of a light bulb. It is indeed good to check that everything is properly soldered, but first remember to switch off the power, because any electrical operation must be done safely .

Or, if you notice that the light bulb has suddenly gone out and burnt out, a short circuit could be the cause. But why does this happen? It may happen that the electric current does not work in its established path, therefore a strong friction occurs .

Continued on next page

In this case, the defective part must be repaired. In short, the causes can be varied, but do you know how to repair a burnt-out light bulb in no time? We’ll tell you how electricians do it. Very little is enough: Let’s find out more.

The procedure for repairing a burnt-out light bulb: simple and quick.
To repair a burnt-out light bulb, you will need a small screwdriver, insulating tape, LED wire and needle-nose pliers. Before you start, remember to disconnect the bulb from the mains – this is the first step to working safely.

First remove the broken LED bulb from the lamp using the screwdriver. Be careful not to touch the glass of the bulb, otherwise you could burn yourself. Once you have removed the broken bulb, pull the filament out of the broken bulb using needle-nose pliers.

Next, you need to replace the LED string that you bought at your local hardware shop. Solder them together perfectly using adhesive tape. Finally, insert the light bulb into the lamp and switch it back on.

You can fix it in less than two minutes with just a few simple steps. Isn’t that incredible? Do-it-yourself remedies are always the best because they are not only cheap, but also very simple, practical and quick. However, if you don’t have the confidence to carry out this small operation, contact an electrician.